Pressure Systems 9022 Manual do Utilizador descarregar pdf (Página 103)

www.meas-

spec.com

Measurement Specialties Inc. NetScanner System (9016, 9021, & 9022) User’s Manual

1 - 70

Description

‘q’ read

index

01-10

Set Number of Channels in Module (default =16 for

9016, 12 for 9021 and 9022).

Enable Automatic Shifting of Calibration Valve during

Calculate and Set Offsets (‘h’) command (default). (9016

only)

Disable Automatic Shifting of Calibration Valve in ‘h’.

User will manually control calibration value. (9016 only)

Set Cal Valves to RUN or LEAK Position (default)

— choice made by ii=12. (9016 only)

Set Cal Valves to CAL/RE-ZERO or PURGE Position

— choice made by ii=12. (9016 only)

see

chart

below

0D-0E

Reserved for factory use

Disable periodic Thermal Coefficient Update task.

Enable periodic Thermal Coefficient Update task

(default).

01-20

Set Number of A/D Samples to Average. (default = 8).

Valid values are 1, 2, 4, 8,10, 20 hex: (1, 2, 4, 8,16, 32

decimal)

Reserved for factory use

Set Cal Valves to RUN or CAL/RE-ZERO Position

(default) — choice made by ii=0C. (9016 only)

Set Cal Valves to PURGE or LEAK Position — choice

made by ii=0C. (9016 only)

see

chart

below

Use Static IP Address Resolution (default)

Use Dynamic IP Address Resolution (RARP/BOOTP)

(Results in immediately becoming the module’s new

power-on default)

Disable Host Response/Stream Back-Off Delay (default).

Enable Host Response/Stream Back-Off Delay as

low-order byte of Ethernet Address(converted to decimal

value * 20 µsec.).

Enable Host Response/Stream Back-Off Delay specified

per eeee as decimal value (* 20 µsec.)

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 193 194

Comentários a estes Manuais

Sem comentários

Pressure Systems 9022 Manual do Utilizador Página 103

Comentários a estes Manuais